Technical component registers and entries

  • Updated

When you install, remove or move technical components, maintool posts technical component ledger entries. Each posting run creates a technical component register for this. This lets you trace without gaps when a component was installed where. With the Technical Component Register report, you print these changes.

Technical Component Registers

Search for Technical Component Registers. The page shows one line per posting run with No., Creation Date, User ID, Source Code, Journal Batch Name and the From Entry No. and To Entry No. of the posted entries. Use the Technical Component Ledger Entries action to open the entries of the selected register.

Technical Components Ledger Entries

The entries show the installation and removal history. You open them, for example, on the technical component card via Ledger Entries, on a mounting position card via Technical Component Ledger Entry, on a component place or in the technical component journal.

Field Meaning
Posting Date, Document No. Date and document of the posting.
Entry Type What was posted, for example Connect or Disconnect.
Work Order No. Related work order, if any.
Description Description of the component.
Mounting Position, Component from, Vehicle No. Where the component was or is installed: in the mounting position, in a parent component or in a vehicle.

You can show further columns such as Component Place, Assignment or dimensions via Personalize. Actions: Dimensions and Navigate. How to install and remove components is described in Installing, Moving and Removing Technical Components.

Technical Component Register report

Location: Maintenance Role Center › Planning › Reports › Technical Component Register, or search for the report. On the Technical Component Register FastTab, you select the registers using the No. filter.

For each register, the report prints the technical component ledger entries in the order in which they were posted, with posting date, entry type, document no., technical component and description, mounting position, parent component and assignment.

maintool also prints the report when you choose Post and Print in the Technical Component Journal. It is set as the Posting Report ID in the journal template.

Operating Status Entries

The Operating Status Entries page is also part of the history. It shows for each technical object when it had which operating status (Object Type, Technical Object No., Operating Status, Start DateTime, end and Duration). You open it via search or on the card of the object, for example a component address or mounting position, via Operating Status Entries. There is no report for it.

Available from version 20261000.0: operating status and operating status entries.

Related articles

Related to

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request