Technical component cannot be installed (component place)

  • Updated

You want to install a technical component in a component place of a higher-level technical component, but the Component Place field is locked, the place you want is missing from the selection, or maintool refuses the assignment or the posting. Usually this is due to the rules from the setup or because the place is already occupied.

How component places work

  • Component places belong to the higher-level technical component. You create them on its card with the Component Places action. The No. of Technical Components column shows how many components are assigned to a place.
  • A technical component can only have a component place together with Component from. Only the places of the component in Component from are available for selection.
  • In the Technical Facility Management Setup (General FastTab), Assignment of Component Place to Technical Component defines whether a place may hold only one component (1 by 1) or several (1 by n). maintool checks this on the card, in the journal and when posting.
  • maintool checks Bind Component Place (Never, Optional, Always) when posting in the technical component journal if Component from is filled in the line.
  • On the card, you can only change Component from and Component Place as long as the component has the Assignment Installation. After that, you install and move components with the journal, see Install, remove and relocate a technical component.

Messages and causes

Message or symptom Cause Solution
The Component Place field on the Technical Component Card cannot be edited. Component from is empty. The component is assigned to a mounting position, a vehicle or not assigned at all. First enter the higher-level technical component in Component from. If Mounting Position No. or Component from Vehicle No. is filled, clear this field first.
The component place you want is missing from the selection. The selection only shows the places of the component in Component from. The place has not been created there. Open the card of the higher-level component, choose the Component Places action and create the place.
Assignment has to be Installation for Tech. Component … The history of the component has already been started (Assignment Bound or Unbound). Install the component in the technical component journal with the entry type Connect or Reconnect and enter the component place there.
… is not a valid value. when entering the component place on the card The setup is set to 1 by 1, and a component is already assigned to the place. Check the No. of Technical Components column in the component places of the higher-level component. Select a free place or first assign the other component to another place.
The number of assigned Technical Components from … could not be bigger than 1! in the journal or when posting As above, but in the technical component journal: With 1 by 1, the place is already occupied. Select a free place. If another component is to vacate the place, first post Disconnect or Reconnect to another place for it.
Error message about the Component from field when you enter a component place in the journal Component from is empty in the line. First enter Component from, then the component place.
Error message when posting that Component Place must have a value Bind Component Place is set to Always. When installing under another component, the place is mandatory. Enter a component place in the line.
Error message when posting that Component Place must be empty Bind Component Place is set to Never, or the line has the entry type Start. Clear the Component Place field in the line.
The Assignment of Component Place to Technical Component could not modified to 1 by 1, because there are some component places existing, which had more than one technical component bound. At least one component place has a No. of Technical Components greater than 1. Distribute the components so that each place holds at most one component. Then change the setup.

Related articles

Related to

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request