Set up threshold monitoring with an activity

  • Updated

With an object monitoring line of the monitoring type Threshold / Range, maintool proposes an activity as soon as a posted measured value exceeds or falls below a threshold or changes too much compared to the previous measured value – for example, an inspection when the temperature of a combined heat and power unit rises above 90 °C. A time schedule describes the activity.

Prerequisites

Create an object monitoring line with a time schedule

  1. Open the technical object (component address, technical component or vehicle) and choose the Monitoring action.
  2. Create a new line and select the Template Code first. maintool copies the Type of Monitoring, Action by Value, Unit of Measure Code and – if specified – the Time Schedule No. from the template.
  3. If the Time Schedule No. is still empty, select the time schedule for the activity.
  4. Choose Object Monitoring Line › Card and fill in the Threshold / Range FastTab.

The fields on the Threshold / Range FastTab can only be edited when Template Code and Time Schedule No. are filled in.

Threshold / Range FastTab

Field Meaning
Action by Value When the activity is due:
  • Minimum Value – measured value smaller than Minimum Threshold,
  • Maximum Value – measured value greater than Maximum Threshold,
  • Both – measured value smaller than Minimum Threshold or greater than Maximum Threshold.
Maximum Threshold Upper limit. Must not be smaller than the Minimum Threshold.
Minimum Threshold Lower limit. Must not be greater than the Maximum Threshold.
Reference Value Target value. Must be between Minimum Threshold and Maximum Threshold.
Maximum Critical Value Additional information. Must not be smaller than the Maximum Threshold.
Minimum Critical Value Additional information. Must not be greater than the Minimum Threshold.
Maximum Negative Deviation The activity is due when the measured value drops by more than this value compared to the previous measured value. Must be smaller than the difference between Maximum Threshold and Minimum Threshold.
Maximum Positiv Deviation The activity is due when the measured value rises by more than this value compared to the previous measured value. Must be smaller than the difference between Maximum Threshold and Minimum Threshold.

Order of entry

maintool checks every entry immediately against the other fields. An empty field counts as 0. Therefore, enter the values in this order:

  1. Action by Value
  2. Maximum Threshold – even if you only monitor falling below, because the minimum threshold must not be greater
  3. Minimum Threshold
  4. Reference Value
  5. if required, the critical values and the deviations

If a value violates a rule, maintool displays, for example, Minimum Threshold could not be bigger than Maximum Threshold! and does not accept the value.

Result: How the date proposal is created

  • maintool compares the last posted measured value of the line with the thresholds according to Action by Value.
  • If deviations are entered, maintool also compares the last posted measured value with the previous one.
  • If a condition applies, the line appears in the date proposal. The date proposal is based only on the thresholds and deviations.

You create the work order from the date proposal, see Create a work order from a date proposal. The Create Work Order action on the object monitoring line is not possible for the monitoring type Threshold / Range; maintool then displays an error for the Type of Monitoring field.

Notes and limitations

  • Deviations can only be evaluated meaningfully if the measured values are posted regularly, for example via an interface to a measurement data acquisition system.
  • There is no extrapolation and no date preview for thresholds.
  • There are no performance characteristics for mounting positions, and therefore no threshold monitoring.
  • For activities based on meter reading or consumption, see Set up counter and consumption monitoring with an activity.

Related articles

Related to

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request